Installing The Oil Pressure Switch - Yamaha Tenere 700 2020 Service Manual

ECA20890
NOTICE
Do not use a torque wrench to tighten the
bolt to the specified angle.
TIP
Tighten the bolts in the tightening sequence cast
on the crankcase.
×5 ×1
2
6
3 1
8. Tighten:
• Crankcase bolts "7"–"27"
Crankcase bolts "7"–"14"
24 N·m (2.4 kgf·m, 18 lb·ft)
Crankcase bolts "15"–"27"
10 N·m (1.0 kgf·m, 7.4 lb·ft)
TIP
• Tighten the bolts "7"–"16" in the tightening se-
quence cast on the crankcase.
• Tighten the bolts "17"–"27" in any tightening
sequence using a crisscross pattern.
4
5
×2
×6
14
13
16
12
9
EAS31071

INSTALLING THE OIL PRESSURE SWITCH

1. Install:
• Oil pressure switch "1"
• Oil pressure switch lead "2"
Oil pressure switch
15 N·m (1.5 kgf·m, 11 lb·ft)
Oil pressure switch lead bolt
1.8 N·m (0.18 kgf·m, 1.3 lb·ft)
2. Apply:
• Sealant
(onto the oil pressure switch threads)
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
TIP
• Apply Three bond No.1215® to the threads "a"
of the oil pressure switch. However, do not ap-
ply Three bond No.1215® to the portion "b" of
the oil pressure switch.
• Install the oil pressure switch lead so that it is
routed within the range shown in the illustra-
tion.
5-64
CRANKCASE
×8
×2 ×3
26 27
23 24
25
17
18
8 10
7 11
15
22 21
19
20