Table of Contents
Advertisement
EAS30551
CHECKING THE FUSES
The following procedure applies to all of the fus-
es.
ECA13680
NOTICE
To avoid a short circuit, always set the main
switch to "OFF" when checking or replacing
a fuse.
1. Remove:
• Rider seat
Refer to "GENERAL CHASSIS (1)" on page
4-1.
2. Check:
• Fuse
a. Connect the digital circuit tester to the fuse
and check the continuity.
Digital circuit tester (CD732)
90890-03243
Model 88 Multimeter with ta-
chometer
YU-A1927
b. If there is no continuity, replace the fuse.
3. Replace:
• Blown fuse
a. Set the main switch to "OFF".
b. Install a new fuse of the correct amperage
rating.
c. Set on the switches to verify if the electri-
cal circuit is operational.
d. If the fuse immediately blows again, check
the electrical circuit.
Fuses
Main
ABS motor
ABS solenoid
Headlight
Signaling system
Ignition
Fuel injection system
Radiator fan motor
Accessory
Parking lighting
ABS control unit
Backup
Auxiliary
Spare
Amperage
Q'ty
rating
30 A
1
30 A
1
20 A
1
10 A
1
7.5 A
1
10 A
1
10 A
1
10 A
1
10 A
1
7.5 A
1
7.5 A
1
7.5 A
1
2.0 A
1
30 A
1
8-130
ELECTRICAL COMPONENTS
Fuses
Spare
Spare
Spare
Spare
EWA13310
WARNING
Never use a fuse with an amperage rating
other than that specified. Improvising or us-
ing a fuse with the wrong amperage rating
may cause extensive damage to the electri-
cal system, cause the lighting and ignition
systems to malfunction and could possibly
cause a fire.
4. Install:
• Rider seat
Refer to"GENERAL CHASSIS (1)" on page
4-1.
EAS31006
REPLACING THE ECU (engine control unit)
1. Turn the main switch to "OFF".
2. Replace the ECU (engine control unit).
Refer to "REMOVING THE ECU (engine con-
trol unit)" on page 4-3.
3. Clean the throttle bodies and reset the ISC
(Idle speed control) learning value.
Refer to "Cleaning the ISC (idle speed con-
trol) valve" on page 7-10.
4. Reset the O
feedback learning value. Use
2
the diagnostic code number "87".
Refer to "SELF-DIAGNOSTIC FUNCTION
AND DIAGNOSTIC CODE TABLE" on page
9-1.
5. Check:
• Engine idling speed
Start the engine, warm it up, and then mea-
sure the engine idling speed.
Engine idling speed
1250–1450 r/min
EAS30552
CHECKING AND CHARGING THE BATTERY
TIP
Refer to "CHECKING AND CHARGING THE
BATTERY" in "BASIC INFORMATION" (sepa-
rate volume).
Amperage
Q'ty
rating
20 A
1
10 A
2
7.5 A
1
2.0 A
1
Advertisement
Chapters
Table of Contents
Troubleshooting
