Installing The Camshafts - Yamaha Tenere 700 2020 Service Manual

2
2
EAS30269

INSTALLING THE CAMSHAFTS

1. Align:
• Mark "a" on the generator rotor
(with the slot "b" in the generator rotor cover)
a. Turn the crankshaft counterclockwise.
b. When piston #1 is at TDC, align the TDC
mark "a" on the generator rotor with the
slot "b" in the generator rotor cover.
2. Install:
• Intake camshaft sprocket "1"
Intake camshaft sprocket bolt
24 N·m (2.4 kgf·m, 18 lb·ft)
ECA19980
NOTICE
Be sure to tighten the camshaft sprocket
bolts to the specified torque to avoid the
possibility of the bolts coming loose and
damaging the engine.
TIP
• Make sure that the marks "a" on the intake
camshaft sprocket are aligned with cam lobe
#1 "b" as shown in the illustration.
• While holding the intake camshaft sprocket
with the rotor holding tool "2", tighten the intake
camshaft sprocket bolts in the proper tighten-
ing sequence as shown.
1
b
a
5-16
Rotor holding tool
90890-01235
Universal magneto and rotor
holder
YU-01235
a
2
1
3. Install:
• Decompressor lever pins "1"
• Decompressor lever #1 "2"
• Decompressor lever #2 "3"
TIP
• Face the cutout "a" in each decompressor le-
ver pin toward the exhaust camshaft sprocket.
• Install the decompressor lever pins, decom-
pressor lever #1, and decompressor lever #2
into the exhaust camshaft as shown in the illus-
tration.
1
a
4. Install:
• Exhaust camshaft sprocket "1"
Exhaust camshaft sprocket bolt
24 N·m (2.4 kgf·m, 18 lb·ft)
CAMSHAFTS
1
b
1
2
2 1 3
a
1 1