Table of Contents
Advertisement
. Enable Remote Control from the PJP-MC
Configure the ProjectPhone to accept control signals from the PJP-MC24 used to start
conferences.
Note
• If you do not configure the ProjectPhone to allow remote control from the PJP-MC24, it will not
be able to participate in scheduled conferences. Be sure to enable remote control.
• If a password is set for the ProjectPhone, the PJP-MC24 cannot implement communication
control even when the remote control is enabled. Cancel the ProjectPhone password, if set.
To allow remote control, follow these steps using the ProjectPhone keys:
1
On the initial screen, press the
The Menu screen appears.
2
Press the
key.
The Settings menu screen appears.
3
Press the
the
The General Settings screen appears.
4
Press the
the
The Remote Control screen appears.
5
Press the or
key.
Remote control from the PJP-MC24 is now enabled.
or
key and select Settings, and then press the
or
key and select General Settings, and then press
key.
or
key and select Remote Control, and then press
key.
key and select Enable, and then press the
key.
Advertisement
Table of Contents
