Am/Fm Tuner; Connecting The Antennas - Yamaha RX-V3000RDS Owner's Manual

Connecting the Antennas

Both AM and FM indoor antennas are included with this unit. These antennas should provide sufficient signal strength in most situations.
However, a properly installed outdoor antenna provides clearer reception. If you experience poor reception quality using the indoor antennas,
an outdoor antenna may improve the reception.
Connect each antenna as shown below.
Indoor FM antenna (included)
TUNER
– GND
FM ANT
L
L
R
2
Loop Antenna
Antenna stand

AM/FM Tuner

AM loop antenna (included)
CAUTION
SEE INSTRUCTION MANUAL FOR
AM
ANT
R
75
UNBAL.
L R
Ground
Connecting the AM loop antenna
1
1 Press the tab to unlock the terminal hole. 1
2 Insert the AM loop antenna lead wires to the AM ANT and GND terminals.
2
3
3 Lift the tab to its original position to lock the lead wires. 3
4 Attach the loop antenna to the antenna stand.
4
5 Orient the AM loop antenna so that the best reception is obtained.
5
Connecting the indoor FM antenna
Connect the included indoor antenna to the 75 UNBAL.
FM ANT terminal.
Optional outdoor FM/AM antenna
Consult your dealer or authorized service center about the
best method of selecting and erecting outdoor antennas.
Lightly pull on the lead wires to confirm a good connection.
Notes:
• The AM loop antenna should be placed away from this unit. The antenna may be
hung on a wall.
• The AM loop antenna should remain connected, even if an outdoor AM antenna is
connected to this unit.
• To minimize the influence of automobile ignition noise, locate the antenna as far
from heavy traffic as possible.
• Keep the ribbon cable or coaxial cable as short as possible.
Do not bundle or roll up excess cable.
• The antenna should be at least 1.8m (6 feet) from reinforced concrete walls and
metallic structures.
29