Changing The Speaker Impedance Setting (Speaker Imp.); Turning On/Off The Remote Control Sensor (Remote Sensor); Selecting The Remote Control Id (Remote Con Amp); Changing The Fm/Am Tuning Frequency Setting (Tuner Frq Step) - Yamaha RX-A3060 Owner's Manual

Changing the speaker impedance setting
(SPEAKER IMP.)
SPEAKER IMP.
8¬MIN
Change the unit's speaker impedance settings depending on the impedance of the speakers
connected.
Settings
Select this option when you connect 6-ohm speakers to the unit. You can also use
6 Ω MIN
4-ohm speakers as the front speakers.
8 Ω MIN Select this option when you connect 8-ohm or higher speakers to the unit.
Turning on/off the remote control sensor
(REMOTE SENSOR)
REMOTE SENSER
ON
Turn on/off the remote control sensor on the main unit. While the remote control sensor is
turned off, you cannot control the unit from the remote control.
Settings
ON Turns on the remote control sensor.
OFF Turns off the remote control sensor.

Selecting the remote control ID (REMOTE CON AMP)

REMOTE CON AMP
Change the unit's remote control ID so that it matches the remote control's ID (default: ID1).
When using multiple Yamaha AV receivers, you can set each remote control with a unique
remote control ID for its corresponding receiver.
Settings
ID1, ID2
⬛
Changing the remote control ID of the remote control
1
To select ID1, hold down the cursor key (e) and SCENE 1 together for 3 seconds.
To select ID2, hold down the cursor key (e) and SCENE 2 together for 3 seconds.
Changing the FM/AM tuning frequency setting
(TUNER FRQ STEP)
(Brazil, Asia and General models only)
TUNER FRQ STEP
FM50/AM9
Change the FM/AM tuning frequency setting of the unit depending on your country or region.
Settings
Select this when you want to adjust the FM frequency by 100-kHz steps and AM by
FM100/AM10
10-kHz steps.
Select this when you want to adjust the FM frequency by 50-kHz steps and AM by
FM50/AM9
9-kHz steps.
154
En
ID1