Others; Impedance Selector Switch; Connecting The Ac Power Cord - Yamaha RX-V3000RDS Owner's Manual

Hookups

Others

WARNING
Do not change the IMPEDANCE
SELECTOR switch setting while the power to
this unit is on, otherwise this unit may be
damaged.
IF THIS UNIT FAILS TO TURN ON
WHEN THE STANDBY/ON SWITCH IS
PRESSED:
The IMPEDANCE SELECTOR switch may
not be set to either end. If so, set the switch to
either end when this unit is in the standby
mode.
G.
IMPEDANCE SELECTOR
SET BEFORE POWER ON
FRONT : 6 MIN./SPEAKER
REAR : 6 MIN./SPEAKER
REAR CENTER : 6 MIN./SPEAKER
CENTER : 4 MIN./SPEAKER
MAIN A OR B : 4 MIN./SPEAKER
A + B : 8 MIN./SPEAKER
FRONT : 8 MIN./SPEAKER
REAR : 8 MIN./SPEAKER
REAR CENTER : 8 MIN./SPEAKER
CENTER : 8 MIN./SPEAKER
MAIN A OR B : 8 MIN./SPEAKER
A + B : 16 MIN./SPEAKER

IMPEDANCE SELECTOR switch

AC Power Cord
R
WER ON
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
N./SPEAKER
IN./SPEAKER
18
IMPEDANCE SELECTOR switch
Select the position whose requirements your speaker system meets.
FRONT EFFECT:
REAR:
REAR CENTER:
CENTER: The impedance of the speaker must be 4 or higher.
MAIN:
FRONT EFFECT:
REAR:
REAR CENTER:
CENTER: The impedance of the speaker must be 8 or higher.
MAIN:

Connecting the AC power cord

Plug in this unit to a wall outlet when all connections are complete.
AC OUTLETS
Use these to connect the power cords from your other components to this unit. The
power to the switched outlets is controlled by this unit's STANDBY/ON
(SYSTEM POWER or STANDBY on the remote). These outlets will supply
AC OUTLETS
power to any connected unit whenever this unit is turned on. The maximum power
(total power consumption of components) that can be connected to AC OUTLETS
is 100 W.
(Upper position)
The impedance of each speaker must be 6 or higher.
The impedance of each speaker must be 6 or higher.
The impedance of the speaker must be 6 or higher.
If you use one pair of main speakers, the impedance of each speaker
must be 4 or higher.
If you use two pairs of main speakers, the impedance of each speaker
must be 8 or higher.
(Lower position)
The impedance of each speaker must be 8 or higher.
The impedance of each speaker must be 8 or higher.
The impedance of the speaker must be 8 or higher.
If you use one pair of main speakers, the impedance of each speaker
must be 8 or higher.
If you use two pairs of main speakers, the impedance of each speaker
must be 16 or higher.
Caution:
• Do not use other AC power cords than the one provided.