Flow Control (Port One Tab); Parity (Port One Tab); Data Bits (Port One Tab); Stop Bits (Port One Tab) - Siemens VIU-20 Installation And Instruction

VIU WEB BROWSER USER INTERFACE
_________________________________________________________________________________________________________
7.3.9.8

Flow Control (Port One tab)

Select the flow control for the Serial Port One.
Serial Port One Flow Control options: None, Hardware (default = None)
7.3.9.9

Parity (Port One tab)

Select the parity setting for Serial Port One.
Serial Port One parity options: None, Even, Odd (default = None).
7.3.9.10

Data Bits (Port One tab)

Select the data bit setting for Serial Port One.
Serial Port One Data Bit options: 7, 8 (default = 8).
7.3.9.11

Stop Bits (Port One tab)

Select the stop bit setting for Serial Port One.
Serial Port One Stop Bit options: 1, 2 (default = 1).
7.3.9.12

Protocol (Port One tab)

Select the protocol setting for Serial Port One.
Serial Port One protocol options: User, NMEA, ACSES (default = User).

7.3.10 Site Info Configuration

The Site Info screen (Figure 7-31) provides fields for entering a site name, the mile post number
and DOT number for the VIU wayside location. It also allows selection of the local time zone.
This screen contains two vital parameters that can only be changed after selecting the Edit Mode
(Figure 7-32). When finished with Edit Mode, the Vital Core must be rebooted to remove the VIU
from the Edit Mode (). This reboots the Vital Core only, and not the entire VIU.
Figure 7-31 Site Info Configuration Screen – Edit Mode Locked
SIG-00-07-11
Version No.: B.2
7-24
SEPTEMBER 2012 (REVISED OCTOBER 2019)