Maintenance - Honeywell ACM 150 Manual To Installation, Operation, And Maintenance

Air composition monitor
Table of Contents

Advertisement

 
ACM 150

Maintenance

Lockout / Tagout Procedure
ACM 150
Before accessing, testing, touching or removing any electrical circuits, plates or
shields in the ACM 150 monitor, disconnect the power following the procedure in
Planned shutdown
Figure
24, is lockable in the Off position, and it provides Lockout / Tagout for the
ACM 150 monitor. It disconnects all electrical power within the system.
DANGER!
Electrocution danger. The Main Power Switch is the tie point for line power,
which connects to terminals inside the switch. Before removing the cover to
this switch to access these terminals, disconnect line power via the external
Lockout / Tagout switch.
After appropriately locking and tagging the switch, verify with a voltmeter or
equivalent suitable device that all electrical voltage into the ACM 150
monitor has been isolated and de- energized. This procedure should be
followed for both the integral Lockout / Tagout switch and any external
disconnects that the user may have.
DANGER!
Dangers d'électrocution . L' interrupteur d'alimentation principal est le point de
puissance de la ligne de partage des voix, qui se connecte à bornes à
l'intérieur du commutateur. Avant de retirer le couvercle ce commutateur pour
accéder à ces bornes , la puissance de la ligne de déconnexion via l' externe
Lockout commutateur / étiquetage .
Après le verrouillage de manière appropriée et de marquage le commutateur ,
vérifier avec un voltmètre ou dispositif approprié équivalent que tout tension
électrique dans le moniteur ACM 150 a été isolé et DE- tension. Cette
procédure doit être suivie pour à la fois le verrouillage intégrante /
commutateur Tagout toute déconnecte externes que le utilisateur peut avoir .
External
A means of disconnecting line power at the source is necessary to allow safe
access to the power terminals at the ACM 150 monitor. An external Lockout / Tagout
switch must be installed for this purpose. Follow your company's Lockout / Tagout
procedure, shutting off and locking this switch when required.
 
 
for both line power and utility gases. The Main Power Switch,
102

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents