Table of Contents
Advertisement
PLAYBACK
Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
y
To play DTS-encoded CDs when using a digital audio
connection, set "DECODER MODE" in "INPUT MENU" to
"DTS" before the playback (see page 94).
Before performing the following operations, press 5 AMP on
the remote control.
Basic procedure
1
Turn on the video monitor connected to this
unit.
y
See page 46 to display the input source information on the
video monitor.
Rotate the R INPUT selector (or press one
2
of the input selector buttons (4)) to select
the desired input source.
The name of the currently selected input source
appears in the front panel display for a few seconds.
Available input sources
MULTI CH
VCR
DVR
V-AUX
Currently selected input source
y
The corresponding input selector button on the remote
control for the currently selected input source lights up for
approximately 5 seconds after you press any buttons on the
remote control, showing which source component is
currently being operated.
42
En
DTV/CBL
DVD
MD/CD-R
CD
TUNER
DVD
Playback
3
Start playback on the selected source
component or select a broadcast station.
• Refer to the operating instructions for the source
component.
• See page 53 for details about FM or AM tuning
instructions.
• See page 58 for details about XM Satellite Radio
tuning instructions.
• See page 63 for details about SIRIUS Satellite
Radio tuning instructions.
• See page 68 for details about iPod operations.
• See page 70 for details about Bluetooth component
operations.
Rotate J VOLUME (or press N VOLUME +/–)
4
to adjust the volume to the desired output
level.
y
• See page 52 to adjust the level of each speaker.
• This does not affect the AUDIO OUT (REC) level.
• You can set the initial volume level and maximum volume
level (see page 89).
Rotate the N PROGRAM selector (or press
5
B PROG l / h repeatedly) to select the
desired sound field program.
The name of the selected sound field program appears
in the front panel display. See page 48 for details
about sound field programs.
XM
SIRIUS
Currently selected sound field program
Note
Sound field programs cannot be selected when the
component connected to the MULTI CH INPUT jacks is
selected as the input source (see page 43).
y
• Choose a sound field program based on your listening
preference, not merely on the name of the program.
• When you select an input source, this unit automatically
selects the last sound field program used with the
corresponding input source.
• To display information about the currently selected sound
field program in the OSD, see page 72 for details.
Sci-Fi
Advertisement
Table of Contents
