Table of Contents
Advertisement
■ AUTO SETUP
Before AUTO SETUP
Error message
Connect MIC!
Unplug HP!
Memory Guard!
During AUTO SETUP
Error message
E-1:NO FRONT SP
E-2:NO SUR SP
E-3:NO PRNS SP
E-4:SBR->SBL
E-5:NOISY
E-6:CHECK SUR.
E-7:NO MIC
E-8:NO SIGNAL
E-9:USER CANCEL
E-10:INTERNAL ERROR
Cause
Optimizer microphone is not connected.
Headphones are connected.
The parameters of this unit are protected.
Cause
Front L/R channel signals are not detected.
A surround channel signal is not detected.
A presence channel signal is not detected.
Only a right surround back channel signal is
detected.
Background noise is too loud.
Surround back speakers are connected,
though surround L/R speakers are not.
The optimizer microphone was unplugged
during the "AUTO SETUP" procedure.
The optimizer microphone does not detect
test tones.
The "AUTO SETUP" procedure was
cancelled due to user activity.
An internal error occurred.
Remedy
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Unplug the headphones.
Set "MEMORY GUARD" to "OFF".
Remedy
Check the front L/R speaker connections.
Check the surround speaker connections.
Check the presence speaker connections.
Connect the surround back speaker to the
LEFT SURROUND BACK SPEAKERS
terminal if you only have one surround back
speaker.
Try running "AUTO SETUP" in a quiet
environment.
Turn off noisy electric equipment like air
conditioners or move them away from the
optimizer microphone.
Connect surround speakers when you use
surround back speakers.
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Check the microphone setting.
Check the speaker connections and
placement.
Run "AUTO SETUP" again.
Run "AUTO SETUP" again.
Troubleshooting
See
page
32
—
97
See
page
14
14
14
14
—
—
14
32
32
14
32
32
117
En
Advertisement
Table of Contents
