Basic Operation; Playback; Playing A Source - Yamaha R-N500 Owner's Manual

BASIC OPERATION

CAUTION
Extreme caution should be exercised when you play back CDs encoded in DTS.
If you play back a CD encoded in DTS on a CD player that does not support DTS, only noise will be heard, and this noise
may damage your speakers. Check whether your CD player supports CDs encoded in DTS. Also, check the sound output
level of your CD player before you play back a CD encoded in DTS.

Playing a source

A (power)
SPEAKERS A/B INPUT selector
SOURCE
ID DIMMER
COAX1 COAX2
LINE1 LINE2
TUNER CD
FM AM
HOME
SETUP
ENTER
DISPLAY
1
Press A (power) on the front panel (or
RECEIVER A on the remote control) to turn
on this unit.
2
Rotate the INPUT selector on the front panel
(or press one of the input selection keys on
the remote control) to select the input source
you want to listen to.
3
Press SPEAKERS A and/or SPEAKERS B on
the front panel or on the remote control to
select speakers A and/or speakers B.
When speaker set A or speaker set B are turned on,
SP A or SP B is displayed on the front display
accordingly (see page 6).
Notes
• When one set of speakers is connected using bi-wire connections,
or when using two sets of speakers simultaneously (A and B),
make sure SP A and SP B are displayed on the front display.
• When listening with headphones, turn off the speakers.

Playback

VOLUME
CODE SET
RECEIVER
RECEIVER A
SLEEP
SPEAKERS
A B
SPEAKERS A/B
OPT1 OPT2
Input selection
LINE3 PHONO
keys
USB NET
PLAYING
OPTION
VOLUME
VOLUME
RETURN
4
Play the source.
5
Rotate the VOLUME control on the front
panel (or press VOLUME +/– on the remote
control) to adjust the sound output level.
y
You can adjust the tonal quality by using the BASS, TREBLE,
BALANCE and LOUDNESS controls or the PURE DIRECT
switch on the front panel.
6
Press A (power) on the front panel again (or
RECEIVER A on the remote control) to finish
using this unit and set it to standby mode.
■ Using the PURE DIRECT switch
Routes input signals from your audio sources so that the
input signals bypass the BASS, TREBLE, BALANCE and
LOUDNESS controls, thus eliminating any alterations to
the audio signals and creating the purest possible sound.
The PURE DIRECT indicator lights up and the front
display turns off after a few seconds.
Notes
• The BASS, TREBLE, BALANCE, and LOUDNESS controls
do not function while the PURE DIRECT feature is turned on.
• This setting is retained even if you turn off this unit.
Playback
PURE DIRECT switch
15
En