Yamaha AV RECEIVER RX-V1065 Owner's Manual page 71

See
Problem Cause Remedy
page
No sound is heard "LFE / Bass Out" is set to "Front" and a Set "LFE / Bass Out" to "Sub'a, oofer" or "Both". 5(,
from the subwoofer. Dolby Digital, DTS or AAC signals is
being played.
"LFE / Bass Out" is set to "Subwoofer" or Set "LFE / Bass Out" to "Both". 56
"Front" and a 2-channel source is being
played.
The source does not contain low
frequency signals.
No sound is heard
"Extended Surround" in the Option menu Set "Extended Surround" other than "OFF' or "Auto". 48
from the surround
is set to "Oft", or an input signal does not
back
speakers,
contain a surround back flag with
"Extended Surround" set to "Auto".
The audio input The connected component is not set to Set the playback component properly referring to its
sources cannot be output the desired digital audio signals, operating instructions.
played in the desired
digital audio signal
format.
Noise/hum noise is
Incorrect cable connection. Connect the audio cables properly. If the problem
heard, persists, the cables may be detective.
A DTS-CD is being played back. 1) When only noise is output 15, 48
If a DTS bitstream signal is not properly input to this
unit, only noise is output. Connect the playback
component to this unit by digital connection and play
back the DTS-CD. If the condition is not improved,
the problem may results from the playback
component. Consult the manufacturer of the playback
component.
2) When noise is output during playback or skip
operation
Bet_re playing back the DTS-CD, display the Option
menu alter selecting the input source and set
"Decoder Mode" to "DTS".
The volume level
cannot be increased,
or the sound is
distorted.
"Memory Guardt" is
displayed and the
setting cannot be
changed.
There is noise
interference from
digital or radio
frequency equipment.
The component connected to the AUDIO Tnrn on the power of the component.
1/2 jacks of this unit is turned off.
63
"Memory Guard" in "Set Menu" is set to Set "Memory Guard" to "OFF'.
"On".
6O
This unit is too close to other digital or
radio frequency equipment.
Move this unit further away from such equipment.
68
En