Parameters For Adjusting Reverberant Sound; Reverb Level; Parameters For Certain Sound Field Programs - Yamaha AV RECEIVER RX-V1065 Owner's Manual

IW_';tlil,r,e.'t,li,:,pl,r,l,r_,.z,;,/':'_'_z.'_,pl,r,m_'t;e,;oz, lf_[ff[.
• Parameters for adjusting reverberant sound
Reverb Time
Adjustable range: 1.0to 5.0s
Reverb Time parameter adjusts the attenuation time of the
rear reverberant sound based on the time that about lkHz
reverberant sound takes for 60dB of attenuation.
Reverberant sound attenuates faster as you decrease the
value. Reverb Time adjustment allows you to create a
natural reverberant sound, by setting the attenuation time
longer for a sound source or room with less echo, or
shorter for a sound source or room with more echo.
Rear
Rear reverberation Source sound reverberation
Early reflection.,
I
I B
I_1 Time
ReverbTime
Short
reverberation
Soundsource
t
60dB
<
I _ Time
Reverb Time
iLong i
reverberation i |
Small = 1.0s Large = 5.0s
Reverb Delay
Adjustable range: 0 to 250ms
Reverb Delay parameter adjusts the time difference
between the beginning of the direct sound and the
beginning of the reverberation sound. The larger the value,
the later the reverberation sound begins. Increasing the
value of Reverb Delay allows you to create a reverberant
sound in a wider area for the same Reverb Time.
Source sound
= ,
(dB)
60dB
Reverb Delay Reverb Time
Time
Reverb Level
Adjustable range: 0 tol00r/_
Reverb Level parameter adjusts the reverberation sound
level. Increasing the value of Reverb Level makes the
reverbration sound level higher, which allows you to
create more echo.
.J
(dB)
Sourcesound
Parameters for certain sound field
programs
• Parameter for MOVIE sound field programs
Decode Type
Choices:
PLIIx Movie (PLII Movie), Neo:6 Cinema
Selects the decoder type for use with the MOVIE sound
field programs.
• You cannot select a decoder for the following MOVIE sound field
programs.
- Mono Movie
- Sports
- Action Game
- Roleplaying Game
• Parameter for 2ch Stereo
D i rect
Choices:
Auto*, Off
Automatically bypasses the DSP circuit and tone control
circuit when an analog sound source is selected as the
input source. You can enjoy a higher quality sound.
Auto Outputs sound by bypassing the DSP circuit and
tone control circuit when the "Bass" and "Treble"
tone controls are both set to 0 dB.
Off Do not bypass the DSP circuit and tone control.
• Parameters for 7ch Stereo
Center Level / Surround L Level / Surround R
Level / Surround Back Level / Presence L Level /
Presence R Level
Adjustable range: 0 to 100_7_
Adjusts the volume of the center, surround L/R, surround
back and presence L/R channels in the 7ch Stereo
program. The available parameters differ depending on the
setting of the speakers.
52
En