Connecting The Fm And Am Antennas; Connecting The Power Cable; Turning This Unit On And Off; Assembling The Am Loop Antenna - Yamaha AV RECEIVER RX-V1065 Owner's Manual

I_qllll_i(l'lff
An indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Indoor FM antenna Outdoor AM antenna
Connect a 5 to 10 m (16 to
33 ft) vinyl-covered wire,
and extend it outdoors
(use the AM loop antenna
i together with this
antenna).
AM loop
antenna
Ground (GND terminal)
The GND terminal is not for earth grounding.
To reduce noises, connect a ground bar or a
vinyl-covered wire with a copper plate at its tip,
and place it in the moist ground.
• The supplied amenuas are normally sensitive enough to obtain gnod
reception.
• Position the AM loop antenna away fl'om this unit.
• lfynu canuot get good reception, we recommend that you use an outdoor
antenna. For details, cousult the nearest authorized Yamaha dealer or
service center.
• Always use the AM lnop antenna even when the outdonr antenna is
conuected.
Assembling the AM loop antenna
Connecting the AM loop antenna
The wires of the AM loop antenna have no polarity. You
can connect either wire to the AM terminal and the other
to the GND terminal.
After all connections are complete, plug the power cable
of this unit into an AC wall outlet.
To the AC wall outlet
1
Press @MAIN ZONE ON/OFF on the front
panel (or []POWER on the remote control)
to turn on this unit.
2 Press @MAIN ZONE ON/OFF (or
[]POWER) again to turn off this unit
(standby mode).
-_,._
• The trait needs a few seconds until ready to play hack.
• Yuu can also turn on lhis unit by pressing @SCENE (or [}{]SCENE).
• This unit consumes a small amount of electricity even ill the standby
mode. We recommend discnnuecling the power cable from the AC wall
outlet.
Caution
Do not unplug this unit while it is turned on. Doing so
may damage this unit or cause the settings of this unit
to be saved incorrectly.
Press and hold Insert
Release
18 En