Editing Surround Decoders/Sound Field Programs; Setting Sound Field Parameters; Sound Field Parameters - Yamaha RX-V1065 Owner's Manual

Editing surround decoders/sound field programs

Setting sound field parameters

Although the field sound programs would satisfy you as
they are with the default parameters, you can arrange
sound effect or decoders suitable for acoustical conditions
of sources or rooms by setting the parameters.
y
• You cannot configure the parameters when "Memory Guard" is set to
"On" (page 50).
1
Turn on the video monitor connected to this
unit.
2
Press iON SCREEN on the remote control.
The GUI screen appears on the video monitor.
3
Press jCursor n to select "Setup" and then
press jENTER.
4
Press jCursor k / n to select "DSP
Parameter" and then press jENTER.
Sound field program
DSP Parameter
Program Name
Decode Type
DSP Level
P. Initial Delay
P. Room Size
Sur. Initial Delay
Sur. Room Size

Sound field parameters

5
Press jCursor k / n to select "Program
Name" and then press jCursor l / h to
select a sound field program to edit.
6
Press jCursor k / n to select a parameter to
edit and then press jCursor l / h to
change the setting.
For details on functions and adjustable ranges of the
sound field parameters, see "Sound field parameters"
on this page.
y
• Repeat steps 5 and 6 to change other sound field program
parameters.
7
To turn off the GUI screen, press iON
SCREEN.
To initialize the parameters of the selected sound field
program, press jCursor n repeatedly to select
"Initialize" and then press jCursor h. Then, press
jCursor h again to execute the initialization or
jCursor l to cancel it.
40
En
Sci-Fi
PLIIx Movie
0dB
16ms
1.0
2ms
1.0
Set values
Sound field parameters
y
• The default settings are marked with "*".
CINEMA DSP basic parameters
DSP Level
Adjustable range: –6dB to 0dB* to +3dB
Fine adjusts an effect level (level of the sound field effect
to be added). You can adjust the level of the sound field
effect while checking sound levels. Adjust "DSP Level" as
follows.
• The effect sound is too soft.
• There are no differences between effects of the sound
field programs.
→Increase the effect level.
• The sound is dull.
• The sound field effect is added too much.
→Reduce the effect level.
Dialogue Lift
Choices: 0* to 5
Use this feature to adjust the vertical position of the
dialogues in movies. The ideal position of the dialogues is
at the center of the video monitor screen.
If the dialogues are heard at the lower position of the video
monitor screen, increase the value of "Dialogue Lift".
When the value is set to zero, the position is at the lowest.
The position gets higher as you increase the value.
Notes
• This setting is available only when "Extra Speaker Assignment" is set to
"Presence" (page 46).
• You cannot move the dialogue position down from the initial dialogue
position.
3D DSP
Choices:
On*, Off
When CINEMA DSP 3D is enabled, sets whether to use
sound field programs in 3D mode.
The ideal dialogue
position
Move up to the ideal
dialogue position