Assa Abloy Norton 5700 Series Installation Instructions Manual page 8

Prepare Frame and Door for PUSH Side Installation
Become familiar with operator components and fasteners. It is recommended that components remain in box
until installed. Verify there is minimum ceiling clearance for operator installation before proceeding. (Figure 13)
A. Prepare frame.
1. Verify frame reveal width is 2-5/8"-6-3/4"
(67mm-171mm). (Figure 13)
NOTE: If frame reveal is less than 3" (76mm),
arm adjusting rod can be field cut to 9-1/2"
(241mm) measured from centerline of
connecting link bushing assembly.
2. Determine if push or pull and if left hand or right
hand installation. (Figure 14)
NOTE: These steps are for PUSH side only. See
page 5 for PULL side installation.
3. Frame header MUST be flat / without twists.
Backplate of operator can be used as reference.
NOTE: If frame is not flat or is twisted, an
additional steel back plate or shimming is
required. Failure to mount unit properly can
result in improper function of operator or
inability to snap on cover.
4. Using detailed template on page 20, prepare
six (6) holes for 1/4-20 machine screws or 14 x
2-3/4" wood screws. Blind rivet nut (by others)
is suggested for unreinforced hollow metal or
aluminum frames. (Figure 15)
5. For concealed mounted conduit (if applicable):
Prepare two (2) 7/8" (22mm) diameter holes
for conduit, for power input and for switch/
sensor wires.
NOTE: On new construction, these holes will
generally be drilled by frame supplier at their
shop or at time-of-install.
Door Opening Angle
Up to 110°
111° to 170°
8
5700 Series Power Operator - PUSH SIDE Installation
Dim B
15-3/4" (400mm)
13-1/4" (337mm)
Left Hand Shown
Figure 15
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2020-01-27
Figure 13
Pull Side
Push Side
Left Hand
PUSH
Figure 14
Right Hand
PUSH
80-9357-0008-020 Rev 6 01/20