Assa Abloy Norton 5700 Series Installation Instructions Manual page 7

5700 Series Power Operator - PULL SIDE Installation
B. Assemble arms.
1. Insert slide arm rod into slide arm tube. Distance
between pinion square and slide stud is 13-1/2"
(343mm). (Figure 8)
2. Install 9/64" socket head screw included in screw
pack.
NOTE: Center threaded hole of slide arm should
align with seventh hole of slide tube. Stud in
slide arm should point to same side as holes in
slide tube.
C. Install arm assembly to operator.
1. Open door.
2. Using an adjustable wrench, rotate
top pinion 45 degrees toward door
hinge. You will feel resistance from
spring. (Figure 9)
3. While holding pinion at 45 degrees,
slide arm on bottom pinion.
NOTE: Pinion flat should be aligned
as shown. (Figure 10)
4. Secure main arm to pinion with
1/4-20 x 1/2" screw.
5. Insert stud on arm into slider in track
then press clip on backside of slider
onto stud. (Figure 11)
6. To adjust track stop:
• Use allen wrench to loosen set
• Open door to full open position.
• Slide bumper stop until it just
• Tighten set screw in bumper stop
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9357-0008-020 Rev 6 01/20
screw in bumper stop.
touches end of slider.
so bumper will stay in position.
(Figure 12)
Approved 2020-01-27
Figure 8
Figure 9
Figure 10
Arm Stud
Slide
Assembly
Bumper Stop
Figure 12
A
B
Figure 11
Set Screw
7