Assa Abloy Norton 5700 Series Installation Instructions Manual page 5

5700 Series Power Operator - PULL SIDE Installation
Prepare Frame and Door for PULL Side Installation
Become familiar with operator components and fasteners. It is recommended that components remain in box
until installed. Verify there is minimum ceiling clearance for operator installation before proceeding. (Figure 1)
A. Prepare frame for operator.
1. Verify frame reveal is maximum 1/8" (3mm).
(Figure 1)
2. Determine if push or pull and if left hand or right
hand installation. (Figure 2)
NOTE: These steps are for PULL side only.
See page 8 for PUSH side installation.
3. Frame header MUST be flat / without twists.
Backplate of operator can be used as reference.
NOTE: If frame is not flat or is twisted, an
additional steel back plate or shimming is
required. Failure to mount unit properly can
result in improper function of operator.
4. Using detailed template on page 19, prepare
six (6) holes for 1/4-20 machine screws or 14 x
2-3/4" wood screws. Blind rivet nut (by others)
is suggested for unreinforced hollow metal or
aluminum frames. (Figure 3)
5. For concealed mounted conduit (if applicable):
Prepare two (2) 7/8" (22mm) diameter holes
for conduit, for power input and for switch/
sensor wires.
NOTE: On new construction, these holes will
generally be drilled by frame supplier at their
shop or at time-of-install.
Door Opening Angle
Up to 110°
111° to 180°
B. Prepare door for track.
1. Using template on page 19, locate and
prepare holes in door for three (3) 3/8"
(9.5mm) sex bolts (Figure 4)
NOTE: Standard units are supplied
with sex nuts and bolts for 1-3/4"
(44mm) thick door. Sex nuts and
bolts for other door thicknesses are
available to order.
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9357-0008-020 Rev 6 01/20
Dim A
15-1/2" (394mm)
13-1/4" (337mm)
Approved 2020-01-27
Figure 1
Right Hand
PULL
Figure 2
Right Hand Shown
Figure 3
Right Hand Shown
Figure 4
Push Side
Pull Side
Left Hand
PULL
5