Assa Abloy Norton 5700 Series Installation Instructions Manual page 6

Install Operator
A. Remove cover from unit and set cover and screws aside.
B. Mount unit to frame. (Figure 5)
NOTE: Conduit hole nearest hinge is suggested
for 120VAC power input.
Select Concealed or Surface option.
Concealed Wired Units Only:
• Connect conduit to frame side of backplate.
OR
• Secure unit to frame with six (6) screws.
Surface Wired Units Only:
• Secure unit to frame with six (6) screws.
• Mount conduit bracket (found in screw pack)
to unit backplate with two (2) provided
screws.
• Connect wiring conduit to bracket.
Install Track and Arm
A. Mount track to door.
1. Using previously prepared holes in
door, install three (3) 1/4-20 x 1-5/8"
screws through track and into sex
bolts. (Figure 6)
NOTE: (Figure 7)
• Opening of track is toward top
of door.
• Adjustable bumper stop is toward
hinge edge of door.
6
5700 Series Power Operator - PULL SIDE Installation
Adjustable Bumper Stop
Figure 7
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Approved 2020-01-27
Figure 5
Figure 6
Track Opening
80-9357-0008-020 Rev 6 01/20