TechniSat DIGITRADIO 10 IR Manual page 142

> Now select whether to allow automatic retrieval of the IP address, gateway
etc. from your router (DHCP active) or if you would like to enter this manually
(DHCP inactive).
Please take into account that automatic retrieval of the IP address, gateway,
subnet mask only works if the DHCP function is activated in your router.
> One by one, enter the IP address, subnet mask, gateway address, primary
DNS and secondary DNS if required, using the Arrow buttons on the remote
control. Confirm each set value with the OK button.
> Now enter the name (SSID) of your WLAN network using the virtual keyboard
and confirm with OK.
> Select whether your WLAN network is Unencrypted, encrypted by WEP or by
WPA/WPA2 and confirm the following item.
> Then use the virtual keyboard to enter your WLAN password and confirm with
OK to start the connection process.
In general, the WLAN connection can be used after a few seconds.
142