712 Verification (V1.2 Through V1.9) - Fluke 71X Series Calibration Manual

71X Series
Calibration Manual

712 Verification (V1.2 through V1.9)

1. Push  button until Input comes up on the display.
2. Push  until PT100 392 JIS is on the display.
3. Push  until 4W is on the display. Set temperature standard to C.
4. Set the 5520A to 2-wire output with 2-wire compensation turned off; then make 2-
5. Set the 5520A to output the RTD (resistance) values in Table 36. Verify that the
5520A Outputs (C)
-180 (25.799 Ω)
100 (139.171 Ω)
550 (300.822 Ω)
6. Remove the 4-wire connection on the 712 (rightmost connection). Push  once and
7. Restore the 4-wire connection to the 712 and maintain 2-wire connection on the
8. Push  until Ω is displayed.
9. Set the 5520A to source resistance, to a 2-wire output, with 2-wire compensation
10. Set the 5520A to source the resistance values in Table 37. Verify that the resistance
11. Make 2-wire connections on the 712 to 4-wire connections on the Fluke 8508A . Set
12. Push  until OUTPUT is displayed.
13. Set the 712 to output the resistance values in Table 38. Verify that the Fluke 8508A
30
wire connections on the 5520A to 4-wire connections on the 712. Set the 5520A to
PT 3916 (ITS-90) mode.
temperature readings are within the limits shown for 4-wire UUT.
Table 36. 712 Verification RTD Values
-179.5 to -180.5
99.5 to 100.5
549.5 to 550.5
verify that 3W is on the display and that the temperature readings are within the limits
shown for 3-wire readings. Push  to return to 4W mode.
5520A.
turned off.
values on the 712 are within the limits shown.
Table 37. 712 Verification Resistance Values
5520A Outputs (Ω)
5.00
300.00
1500.0
3000.0
the Fluke 8508A to measure 4-wire resistance.
readings are within the limits shown.
3-wire 712 Readings (C)
4-wire 712 Readings (Ω)
4-wire 712 Readings (C)
-179.7 to -180.3
99.7 to 100.3
549.7 to 550.3
4.90 to 5.10
299.90 to 300.10
1499.5 to 1500.5
2999.0 to 3001.0