Evaluation; Usual" Mode; Taking A Blood Pressure Measurement Using This Instrument; Diag." Mode - Microlife Watch BP Home Manual

Evaluation

After measurements have been carried out on 7 working days, you
should bring the monitor to the doctor for evaluation of your home
blood pressure values. The doctor will then read the values directly
from the monitor, as described in this manual.
The device automatically recognises, when measurements
have been carried out on 7 days. The doctor symbol BK will
flash on the screen, if an attempt is made to carry out more
measurements.
«USUAL» Mode
In this mode, the device functions like a normal blood pressure
monitor – single measurements are automatically stored and can be
evaluated by a doctor.
Select the «USUAL» mode to take and store measurements at
any times (outside the time range of the «DIAG.» mode, for
any additional measurement or after completion of the diag-
nosis phase).
4. Taking a Blood Pressure Measurement using this
Instrument
«DIAG.» Mode
Move the slide switch AT to «DIAG.» position (indicated by blue dot).
WatchBP Home
Checklist for taking a reliable measurement
1. Avoid activity, eating or smoking immediately before the
measurement.
2. Sit down for at least 5 minutes before the measurement - and
relax.
3. Always measure on the same arm – the arm that gives higher
readings.
4. Remove close-fitting garments from the upper arm.
5. Always ensure the cuff is positioned correctly.
• Fit the cuff closely, but not too tight.
• Make sure that the cuff is 3 cm (1 inch) above your elbow
with the tube on the inside of your arm.
• Support your arm so it is relaxed.
• Ensure that the cuff is at the same height as your heart.
6. Press the ON/OFF button 1 to start the measurement.
7. The «DIAG.» symbol flashes to confirm the correct mode selec-
tion. Then a 60 second count down starts to make sure that you
are relaxed before the measurement. the last 5 seconds are
indicated by beep sounds.
7 EN