Data Transfer To The Computer; Installation Of The Software Program; How To Transfer Data To The Computer - Microlife Watch BP Home Manual

Before deleting values, you should show them to your
doctor. Only delete the memories, when you are sure that you
no longer need the values.
If you want to give the device to another patient, ensure that
both memories have been deleted.
Individual values cannot be deleted.
1. With the monitor switched off, move the switch AT to the mode
with the data you want to delete.
2. Press the M-button 3 and hold it until the delete symbol BO
flashes.
3. Release M-button 3 and press it once more while the delete
symbol BO flashes.
4. To delete the other memory, repeat the procedure 1-3.

6. Data Transfer to the Computer

This device can be connected to a computer to transfer stored values.
Note minimum system requirements stated on the CD.

Installation of the software program

Only connect the computer and the device, when you are
prompted to.
10
1. Put the CD in the CD-ROM drive of your computer. Alternatively
click on «SETUP.EXE» in the CD's directory.
2. An installation window appears on the computer monitor – simply
follow the instructions.
3. When installation is finished, restart the computer before you
work with the program.

How to transfer data to the computer?

1. Start the software program and connect the device to the
computer using the cable supplied.
2. A successful connection is displayed by «Connected» on the
screen.
3. Enter the name, identity number and date of birth of the patient.
To transfer the «DIAG.» mode values click «Download».
All values with a « » designation are used to calculate averages.
If necessary you can remove the checkmark and the corresponding
value will not be used to calculate the average.
To store values, click «Save». The data is stored in a data table.
− The file name is formed automatically from the patient's iden-
tity number and the suffix «Dmode.xls» for stored values from
the «DIAG.» mode.
− To view the data later, click «Patient Files».