Troubleshooting - Yamaha MU50 Owner's Manual

Troubleshooting

Even though the MU50 is exceptionally easy to use, it may occasionally
not function as you expect it to. If that happens, check the possible prob-
lems and solutions below before assuming that the instrument is faulty.
If you are using an AC adaptor, check that the adaptor is properly plugged into both
the AC outlet and the MU50 (See page 12.)
Check that:
The panel volume control is set to an appropriate level.
Other volume-related parameters are set to appropriate levels. (See Volume and
Expression in the Single Part controls, pages 37—38, and Master Volume and
Master Attenuator in the All Part controls, page 41.)
Mute or Solo are not active. (See page 23.) If a Part is being muted, or an empty
Part is being soloed, you may not get any sound.
The Variation effect settings are appropriate. No sound will be output at all if
Variation Connection is set to INS (page 92), Variation Send is turned on for the
Part (page 39), and NO EFFECT is selected for the Variation Type (page 90).
The easiest solution in such a case is to turn off Variation Send for the Part.
The EG Attack Time (page 46) is appropriately short, for short percussive
sounds.
The Velocity Sensitivity Offset (page 56) is appropriate.
The Note Limit Low and Note Limit High (page 57) settings are appropriate. If
the former is set higher than the latter, no sound will be output.
The Velocity Limit Low and Velocity Limit High (page 59) settings are appropri-
ate. If the former is set too high and the latter too low, no sound may be output.
Check all MIDI connections, making sure that the MIDI OUT of the external device
is connected to the MIDI IN of the MU50, and that the MIDI IN of the external device
is connected to the MIDI OUT of the MU50. (See pages 28—29.) Or, if you are using
the TO HOST terminal with a computer, make sure that the terminal is properly con-
nected to the computer and that the HOST SELECT switch is properly set for your
particular computer. (See pages 25—28.) Also, make sure that you have turned on the
connected MIDI instrument or computer before turning on the MU50. If you haven't,
simply turning the MU50 off and back on again may solve the problem.
The maximum polyphony of the MU50 may be exceeded. The MU50 can play no
more than 32 notes at once. (Though 32 notes may seem to be more than enough,
you may run short when playing a connected keyboard along with some densely
arranged song data.)
Check all Reverb-, Chorus- and Variation-related controls: Reverb Send, Chorus Send
and Variation Send in Single Part controls (pages 39); Reverb Return, Chorus Return
and Variation Return (when Variation Connection is set to SYS) in All Part controls
(pages 41—42). Also check the individual effect settings; if no Type has been selected,
or if the parameter settings are too low, there may be no effect sound.
Make sure that the INPUT control is set to an appropriate level. Also for best re-
sults, make sure that the input type (guitar, keyboard, audio) is set to match the
input you are using.
APPENDIX
123