Assa Abloy Norton 6300 Series Installation And Instruction Manual page 7

6
Push Side End Cap Installation
A. Install (2) 1/4-20 x 3/8" length cap
screws in center tapped holes on
each end of the Back Plate
leaving about 3/16" gap between
head of screw and back plate.
B. Slide appropriate end cap (shown
at right) behind the screw heads
from Step 11A and tighten
screws. NOTE: The end cap with
the 3-position switch is always
located on the conduit side of the
Back Plate.
C. Plug the 3-position switch
connector from the end cap into
the main board 123 HOLD OPEN
connector and fan connector from
fan to backplate board.
7
Push Side Arm Installation
Illustration at right shows the operator
looking up from the floor.
A. Attach the main arm to bottom
pinion square as shown at right.
B. Use the 1/4-20 x 7/8" cap screw and
nut to secure the arm onto the
pinion square.
C. Slide rod attached to main arm into
end of tube arm. NOTE: May have
to open door for rod to slide into the
arm tube.
D. With the door fully closed, rotate
main arm toward latch edge of door
until arm tube is at 90° angle
(perpendicular) to the door.
E. Use arm screw provide with the
main arm / rod assembly to secure
the rod and tube arms together.
Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Conduit Holes
Endcap Assembly w/ switch
90 Degrees
Page 7
Endcap Assembly w/ fan
1/4-20 X 3/8"
Cap Screws
Slide rod into tube and rotate main
arm to position as shown.
Arm
Screw
80-9363-0003-020 Rev 8 11/17