Cover Installation - Assa Abloy Norton 6300 Series Installation And Instruction Manual

14
Connector Inputs (cont.)
Input 6: Hold Open
Continuous contact closure of this input triggers the operator to go to the open position and stay there
until the contact is removed. If the door is pulled away from the open position, the operator will close
completely and reopen to the open position and stay in the open position until the contact is removed.
Input 7: Obstruction 1
Contact closure of this input while the door is open or closing triggers the operator to return to the
open position. This is used in conjunction with presence sensors mounted to the closing side of a door
to prevent the door from hitting an obstruction.
Input 8: Obstruction 2
Contact closure of this input while the door is closed or opening triggers the operator to stall. If the
contact is not removed after 10 seconds of closure, the operator will return to the closed position. This
is used in conjunction with presence sensors mounted to the opening side of a door to prevent the
door from hitting an obstruction.
Input 9: Security Override
Continuous contact closure of this input triggers the operator to disable Input 2 / Activation 2. This is
typically used for switching off an outside wall plate.
Input 10: Spare input for Special Application Requests.
Input 11: Spare input for Special Application Requests.
15

Cover Installation

A. Align the cut outs in the cover to the pinion
squares.
B. Use the end caps and body as a guide to slide
the cover onto the unit.
C. Push / snap cover so it locks securely to the
back plate.
WARNING: Make sure no wiring is loose or can
be caught by the cover when it is snapped
into place.
D. For pull side units, cover can be snapped onto
track.
Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Right Hand Push
Side shown
Page 13 80-9363-0003-020 Rev 8 11/17