Assa Abloy Norton 6300 Series Installation And Instruction Manual page 4

1
Push Side Back Plate Mounting Sequence
IMPORTANT BEFORE STARTING: RH DOOR SHOWN WITH HINGE ON RIGHT AND PUSHES AWAY
FROM YOU. FOR LH DOOR WITH HINGE ON LEFT, ROTATE BACK PLATE 180°. NOTE: THE 4-7/8"
CONDUIT HOLES ARE ALWAYS LOCATED ON THE LATCH END OF THE DOOR. FOR DOORS
THAT MOUNT ON THE OPPOSITE SIDE OF THE FRAME (DOOR PULLS TOWARD YOU), SEE PULL
SIDE TEMPLATE. USE TEMPLATE FOR THE FOLLOWING INSTRUCTIONS.
Step A: Measure and mark frame for first mounting hole (see template). Drill using #7 drill and
tap hole using 1/4-20 UNC-2A tap if using 1/4-20 machine screws. If self-drilling self-
tapping screws are used, drill first mounting hole using a 3/16" drill and supplied screw.
Note: Holes used for mounting the Back Plate are marked with a center mark on PUSH
side template at the back of this instruction.
Step B: Attach Back Plate to frame with screw from Step 1A without completely tightening screw.
Step C: Using the Back Plate as a guide, mark second hole (shown on template) using a center
punch if necessary and repeat step 1A drilling / tapping procedure.
Step D: With the Back Plate in the correct position and level with the frame, tighten screws from
steps 1B and 1C.
Step E: Using the Back Plate as a guide, drill and tap remaining 8 holes in the frame using
drilling / tapping procedure from step 1A. Tighten screws.
Step F: Measure and mark arm tube mounting holes. Drill using #7 drill bit and tap hole using
1/4-20 UNC-2A tap if using 1/4-20 machine screws. If self-drilling self-tapping screws
are used, drill first mounting hole using a 3/16" drill and supplied screw.
Step G: Use arm tube shoe to locate second hole. Repeat Step 1F drilling / tapping procedure.
Step H: With longer side of arm shoe pointed toward the hinge, secure arm tube to door.
2
Install Back Plate Board
A. Center Back Plate Board into groove
of back plate. NOTE: The Temp,
Encoder, Fan, and Motor connectors
on the Back Plate Board are
positioned toward the hinge edge of
the plate.
B. Rotate retaining clips (shown at right)
to hold board in groove and tighten
Phillips screw to secure in place.
C. Repeat for second retaining clip.
Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Back Plate
Board
Retaining Clips to
Secure Board
To Back Plate
Position Connector
Page 4
Groove in
Back Plate
Back Plate
Board
80-9363-0003-020 Rev 8 11/17
Temp,
Encoder,
Fan, &
Motor
Connector