Assa Abloy Norton 6300 Series Installation And Instruction Manual page 5

3
Push Side Body Assembly Installation
A. Install the Push Side Body
Assembly to the Back Plate
using the four 1/4-20 x 3-3/4"
length cap screws. Screws
must be tightened in a cross
pattern as shown at right until
all four screws are tight. NOTE:
The mounting pad must go
between the Body Assembly
and the Back Plate.
B. Plug in the four wiring
connectors into the Back Plate
Board. These are the temp,
encoder, motor and position
connectors.
C. Since mounting pad can
compress as screws are
tightened, make sure to double
check screws for tightness.
4
Power Supply / Board Assembly Installation
A. Install (2) 1/4-20 x 3/8" length cap
screws in the top two tapped holes
on the Back Plate leaving about
3/16" gap between head of screw
and back plate.
B. Use the keyholes in the Power
Supply / Board Bracket to slip over
the screw heads installed in Step
4A and allow the slot to drop the
bracket behind the screw heads.
The boards should always be facing
down and the power input for the
power supply should always be
positioned toward the conduit holes.
C. Tighten screws from Step 4A.
D. Plug the two harnesses into the
Back Plate Board connectors.
These are the motor driver and
ribbon connector. Note: See Step 5
on page 6 for orienting the Back
Plate Ribbon Harness for the
proper handing of the door.
Copyright © 2017 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
4
2
Threaded Holes
for Power Supply /
Board mounting.
Conduit Holes
Power Input
Facing Toward
Conduit Holes
Page 5
1
3
Keyhole
1/4-20 X 3/8"
Cap Screws
Board Facing Down
80-9363-0003-020 Rev 8 11/17
Mounting Pad
1/4-20 X 3-3/4"
Length Cap Screws