Pmc400 Multi-Axis Controller/Driver; Esp Series Controller/Driver; Non-Newport Controllers - Newport 850G Series User Manual

CAUTION
Failure to toggle motor power off before attempting to manually position
the 850G will result in damage to the motor gearhead. Manually
positioning should not require more torque to turn the knob with the
actuator attached than with it unplugged. If you are unsure about the
effort required, unplug the actuator to compare the feel of the knob
before proceeding.

2.1.8 PMC400 Multi-Axis Controller/Driver

The PMC400 Controller/Driver has been phased out and is not supported
to drive 850G Series actuators.

2.1.9 ESP Series Controller/Driver

All ESP Series Motion Controller/Drivers are compatible with the 850G
Series actuator. The 850G actuator has an ESP smart chip inside, which
configures the ESP controller/driver, setting default parameters. Thus, the
850G actuator is 'plug-and-play' compatible with the ESP controller/driver.

2.1.10 Non-Newport Controllers

If you are using a non-Newport controller/driver please refer to the
connector pinout provided. Note that in order to utilize the manual knob
feature, power must be removed from the motor (open circuit). Failure to
do so properly may result in dynamic braking on the motor and cause
damage to the gearhead, invalidating your warranty.
5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com