Reinstall Controller Canister - Fujitsu ETERNUS AB Series Hardware Maintenance Manual

3. Carefully lower the HIC into place, and seat the HIC connector by pressing gently on the HIC.
Attention: Possible equipment damage – Be very careful not to pinch the gold ribbon connector
for the controller LEDs between the HIC and the thumbscrew.
4. Hand-tighten the HIC thumbscrew.
Do not use a screwdriver, or you might over tighten the screws.
5. Using a #1 Phillips screwdriver, attach the HIC faceplate you removed from the original HIC with the three
screws.
What to do next
Go to Reinstall controller

Reinstall controller canister

You reinstall the controller canister into the controller shelf after upgrading the HIC.
Procedure
1. Lower the cover on the controller canister and secure the thumbscrew.
2. While squeezing the controller handles, gently slide the controller canister all the way into the controller
shelf.
Note: The controller audibly clicks when correctly installed into the shelf.
canister.
| Host interface cards |
52