Fujitsu ETERNUS AB Series Hardware Maintenance Manual page 20

2. Plug the battery connector back into the board.
What to do next
Go to Install host interface
Install host interface card
If you removed a HIC from the original controller canister, you must install that HIC in the new controller
canister. Install the HIC by gently lowering the card into place and hand tightening the single thumbscrew.
Before you begin
• You must have a replacement controller canister with the same part number as the controller canister you
are replacing.
• You must have a #1 Phillips screwdriver.
• You have an ESD wristband, or you have taken other antistatic precautions.
Procedure
1. Using a #1 Phillips screwdriver, remove the two screws that attach the blank faceplate to the replacement
controller canister, and remove the faceplate.
2. Align the single thumbscrew on the HIC with the corresponding hole on the controller, and align the
connector on the bottom of the HIC with the HIC interface connector on the controller card.
Be careful not to scratch or bump the components on the bottom of the HIC or on the top of the controller
card.
3. Carefully lower the HIC into place, and seat the HIC connector by pressing gently on the HIC.
Attention: Possible equipment damage – Be very careful not to pinch the gold ribbon connector
for the controller LEDs between the HIC and the thumbscrew.
4. Hand-tighten the HIC thumbscrew.
Do not use a screwdriver, or you might over tighten the screw.
card.
| Controllers |
20