Reinstall Controller Canister - Fujitsu ETERNUS AB Series Hardware Maintenance Manual

Hide thumbs Also See for ETERNUS AB Series:
Table of Contents

Advertisement

2. Insert the DIMM squarely into the slot.
The DIMM fits tightly in the slot, but should go in easily. If not, realign the DIMM with the slot and reinsert
it.
Note: Visually inspect the DIMM to verify that it is evenly aligned and fully inserted into the slot.
3. Push carefully, but firmly, on the top edge of the DIMM until the latches snap into place over the notches
at the ends of the DIMM.
Note: DIMMs fit tightly. You might need to gently press on one side at a time and secure with each tab
individually.
What to do next
Go to

Reinstall controller canister

Reinstall controller canister
After installing the new DIMMs, you reinstall the controller canister into the controller shelf.
Procedure
1. Lower the cover on the controller canister and secure the thumbscrew.
2. While squeezing the controller handles, gently slide the controller canister all the way into the controller
shelf.
Note: The controller audibly clicks when correctly installed into the shelf.
3. Reconnect all the cables.
 | DIMMs  |
30

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Eternus hb seriesEternus ab6100

Table of Contents