Fujitsu ETERNUS AB Series Hardware Maintenance Manual page 16

Note: The HIC comes with three screw locations on the top, but is secured with only one.
4. Carefully detach the HIC from the controller card by lifting the card up and out of the controller.
Attention: Be careful not to scratch or bump the components on the bottom of the HIC or on the
top of the controller card.
5. Place the HIC on a flat, static-free surface.
What to do next
Go to Remove power supply.
Remove power supply
Remove the power supply so you can install it in the new controller. When you remove a power supply, you
disconnect the power cord, and slide the part out of the shelf.
Before you begin
• You have an ESD wristband, or you have taken other antistatic precautions.
Procedure
1. Disconnect the power cables:
a) Open the power cord retainer, and then unplug the power cord from the power supply.
b) Unplug the power cord from the power source.
2. Locate the tab to the right of the power supply and press it towards the power supply unit.
| Controllers |
16