Fujitsu ETERNUS AB Series Hardware Maintenance Manual page 21

5. Using a #1 Phillips screwdriver, attach the HIC faceplate you removed from the original controller canister
to the new controller canister with the two screws.
What to do next
Go to Install Power Supply
Install power supply
You must install the power supply into the replacement controller canister. Install the power supply by gently
sliding it into the opening of the new controller.
Procedure
Using both hands, support and align the edges of the power supply with the opening in the system chassis,
and then gently push the power supply into the chassis using the cam handle.
The power supplies are keyed and can only be installed one way.
Attention: Do not use excessive force when sliding the power supply into the system; you can
damage the connector.
What to do next
Go to Install DIMMs
| Controllers |
21