Removing Simms - Yamaha PortaTone PSR-8000 Owner's Manual

• Lug
• After this step the lugs on the slot should
appear in the holes in the ends of the SIMM
module.
V
Replace the SIMM cover and attach with the six screws.
Install the backup batteries, set the PSR-8000 right-side
up, and connect the power cord to the rear-panel AC
INLET jack and an AC outlet.
B
Check that the installed SIMMs are functioning properly.
Turn on the power, go to the SAMPLING display, and
check that the REMAIN TIME value matches the amount
of installed memory, as follows:
4MB x 2
8MB x 2
16MB x 2
No SIMMS
(these values apply when there is no data in the wave
memory)
• Lug
106.9s
202.1s
392.3s
11.8s
4

Removing SIMMs

SIMM modules can be removed after opening the
clamps at both ends of the connector slot.
Installing Options
155