Program Parameters - Ken DW 412 Instruction Manual

Parameters

Program parameters

Description
Program active
A program must be active to be
chosen and started.
Wash time (sec)
Length of the "wash phase".
If this setting is 0, the "wash
phase" and "pause before
rinse" is skipped.
Pause before rinse (sec)
Length of the pause between
"wash phase" and "rinse
phase" in seconds.
Rinse time (sec)
Length of "rinse phase".
Pause after rinse (sec)
Lenth of the pause after rinse
(in seconds).
Wash temperature
The wanted temperature in °C
for washing.
Min. wash temperature
The lowest tempearature in °C
a wash can be started at.
Rinse temperature
The wanted temperature in °C
for rinsing.
Detergent dosing calibration
High/Low wash pressure
Exhaustion during...
Exhaustion after rinse (sec)
Indicates number of seconds
the exhaustion must run after
the rinse phase.
Condensing after rinse (sec)
Indicates number of seconds
the condensator must run after
the rinse phase.
KEN DW 412
Subject to alterations
Possible
Adjustments from factory
adjustments
Prog. 1 Prog. 2 Prog. 3
Yes/no Yes
0-999 60
0-999 15
0-999 12
0-999 15
1-99 57
1-99 49
1-99 80
A-B-C-D A
Low Low
High,
Low/High,
High/Low
None Wash+ Wash+
Wash Rinse Rinse
Rinse
Wash+Rinse
0-999 300
0-999 0
Prog. 4
Yes Yes Yes
120 240 600
15 15 15
12 12 12
15 15 15
57 57 57
49 49 49
80 80 80
A A A
Low Low Low
Wash+ Wash+
Rinse Rinse
300 300 300
0 0 0
User adjustments
Prog. 1 Prog. 2 Prog. 3 Prog. 4
Section/page:16.4
17/9/2013