Installation Instructions; Receipt/Transport/Unpacking; Disposal Of Packaging; Installation/Connection - Ken DW 412 Instruction Manual

Installation instructions

Receipt/transport/unpacking

Disposal of packaging

Installation/connection

Drain pipe
KEN DW 412
Subject to alterations
Check immediately whether the machine has been damaged in transit.
If so, complain to the carrier immediately.
Total machine weight:
KEN DW 412
The easiest way of transporting the machine is by means of a pallet forklift.
Packaging is separated into: Wood, cardboard and plastic, and is disposed
of in accordance with local/national rules on waste disposal.
Table connection:
Lead the entry edge on the table into the machine; the table finishes with a
15 mm entry edge to be placed on the machine edge. Install the tables with
a slope towards the machine to allow the water to run into the machine.
If the machine is to be placed in a corner, do not place any underneath
shelves closer than 500 mm to the machine front plate to allow service.
Water connection:
Connect the machine to cold or hot water, min. 5°C and max. 65°C.
It is important to keep the flow pressure at 15 l/min. at min. 200 kPa and to
never let the static pressure exceed 800 kPa.
Measure the pressure at the machine entry hose.
The coupling line to the machine must be fitted with a blocking valve and a
non-return valve, possible combined as a settable non-return valve.
If the machine is equipped with a rinse aid system or a dosage system, this
must be protected against backflow in line with the VA approval of the
equipment concerned.
The machine must be connected to the water installation with the
accompanying hose or another VA-approved hose.
Poss. decalcifying filter/softening system:
See special instructions for installation, but be aware that the filter may be
connected to max. 65°C hot water as regards KEN filter types TB and MB.
Drain:
The machine can be connected to a floor drain, a sink drain or directly to the
downpipe. In the two last-mentioned cases, a ø50 mm watertrap is required.
The drain pipe may be horizontal, but may not be taken more than 5 m away
from the machine. The water must be able to run off the machine of its own
accord. If required, fit a drain pump to the machine. In such case, remember
that the drain pipe must be lifted to the level shown at illustration.
Excl. packaging
102 kg
Incl. packaging
116 kg
Section/page:4.1
17/9/2013