Program Built-Up; Wash Programs; Wash Pressure - Ken DW 412 Instruction Manual

Program built-up

Wash programs

Wash pressure

Enclosed a start key which
can be placed on the wall
under a table og similar.
KEN DW 412
Subject to alterations
KEN DW410 has 4 programs.
A program consists of:
Wash incl. detergent dosage
Pause
Rinse
Pause
Opening
The programs can be adjusted individually, see section 3.2 - Technical data.
Adjustment of the programs requires specially trained staff and can only be
carried out by knowledge of the special codes required.
These codes are handed out in connection with courses at KEN.
KEN's dishwasher's are adjustet from the factory to wash at 57°C and rinse
at 80°C. If the right temperature has not been reached, the program will be
terminated and a warning is shown on the display.
KEN DW412 has 2 wash pressures:
- high pressure used for pots and pans.
- low pressure applied to glass, cups and other service.
Wash pressure's can be set individually for each program and there is a
opportunity to select programs with high pressure, low pressure or high/low
pressure.
Low pressure:
The program can only be startet with low washing pressure.
The display shows "L".
High pressure
The program can only be startet with high washing pressure.
The display shows "H".
High/low wash pressure:
Both wash pressure can be selected for the program, the display shows
" L/H".
For high pressure press down the start button until the hood starts to go
down - the display change to "H". For low pressure press down shortly on
the start button - the display change to "L".
Low/high wash pressure:
Both wash pressure can be selected for the program, the display shows
" L/H".
For high pressure press down the start button until the hood starts to go
down - the display change to "H". For low pressure press down shortly on
the start button - the display change to "L".
Section/page:6.1
17/9/2013