Detergent Consultant; Calibrating Detergent By Conductivity Dosing - Ken DW 412 Instruction Manual

Detergent consultant

Calibrating detergent by conductivity dosing

KEN DW 412
Subject to alterations
1. Turn on the machine.
2. Press and hold key 4 for 5 seconds until the display shows "ENTER
CODE"
3. Enter the detergent consultant code in the main menu: 24071 to enter the
"DETERG.CONSULT." in the "SERVICE MENU".
4. The machine must be drained for water and the wash tank should be
cleaned before calibration. To make a water change, lift up the standpipe,
the water will now run out of the machine. When the water is out, clean the
filter and wash tank and put the standpipe back in.
If a drain pump is installed in the machine it is emptied by the menu
"CHANGE WATER".
The machine allows up to 4 different detergent settings, named A, B, C and
D, which can be attached to the programs individually.
5. Select "DETER. CALIBRAT." in "DETERGENT CONSULTANT".
6. Select "CALIBRATION A,B,C or D".
7. Press key 2. The hood is opened.
8. Add the wanted quantity of detergent in the wash tank.
At only one detergent setting, normally 60-80 ml detergent is added, see
section 3 - Technical data.
9. Press key 2. The hood is closed.
The machine adds water and starts the detergent calibration.
The hood is opening when the calibration is ended.
10. Press key 2 to end.
13. The calibration is ended and key 2 is pressed to leave the detergent
consultant menu.
If more than one detergent setting is wanted, repeat point 4-10 after
switching between A,B,C and D. (point 6)
Key 1 Key 2
Key 4 Key 3
Section/page:10.1
17/9/2013