Maintenance; Daily Maintenance; Preventive Maintenance - Ken DW 412 Instruction Manual

Maintenance

Daily maintenance

Preventive maintenance

KEN DW 410
Subject to alterations
Regular cleaning:
Clean the outer surfaces of the machine with a moist cloth, possibly using a
polishing agent for stainless steel.
NB! Never use a water hose, pressure rinser or similar.
Chemicals:
Check daily the level of detergent and any other chemicals used in the cans.
Wash and rinse arms:
Check and secure that the wash and rinse arms can rotate freely and that
the nozzles are not clogged.
If a clogged nozzle is unable to be cleaned from the outside, the arms has to
be dismounted and rinsed.
Filter:
Empty the machine for water.
NB!. The machine has to be turned off before draining the water.
Lift up the filter from the wash tank and clean it.
Clean the upper level sensor.
Clean the bottom tank underneath the filter for broken glass, lint, toothpicks
or similar and re-install the filter. Remember to place the standpipe.
NB! Be careful when cleaning the filter and the bottom tank, as there
may be sharp objects.
In addition to the daily maintenance described, it is recommended to carry
out regular inspections to ensure that the machine functions optimally at all
times.
The spindle for the lifting motor must be lubricated after 50.000 washes or
once a year. Use approximately 1 ml of Super Lube (corresponding to 1 cm
on the tube). Do only use the lubricant which is specified by KEN,
Super Lube (spare part No.: 7604545)
NB! All preventive service and maintenance, which require removal of
the machine cladding plates by the use of tools, may only be carried
out by specially trained technical staff.
Section/page:7.1
17/9/2013