Installation/Connection, Continued - Ken DW 412 Instruction Manual

Installation instructions

-installation/connection, continued

KEN DW 412
Subject to alterations
Electricity:
Voltage 3x400V 50Hz. Connect the machine with a 2.5 mm², 5-wire cable
(3 phases, neutral and earth). The fuse size for a 9kW heating element is 16
Amp. Heating elements in wash and rinse tank cannot be engaged at the
same time. For places where a neutral wire does not exist, the machine
must be equipped with a transformer. The machine must be earthed in
accordance with regulations. A main switch must be installed, which is only
to be operated for service. The water connection must be ready before the
power to the machine is turned on.
NB! Check the direction of rotation of the pump before starting up the
machine. If the direction of rotation is wrong, exchange two phases.
Rinse aid:
The integral rinse aid pump has been preset to approx. 2 ml per 10 l.
If this is to be changed, see section 9 - Rinse aid pump, adjustment.
Detergent:
If a detergent dosage unit is built in it has been reset from the factory.
The setting is to be made via computer, see section 8.3 - Detergent
consultant menu.
Front plate.
To loosen the front plate by releasing 2 screws in the bottom of the machine.
The front plate can now be pulled out and released.
Adjustments of leg height:
There are 2 setting options + fine adjustment by adjusting screws.
New height area is obtained by moving the pin (see illustration)
Remember to fasten the screw on the back of the leg.
The indicated measurements are from floor to lead-in edge of the machine.
Adjustment from factory: 890 mm
Adjustment/lower hole: 840-890 mm
Adjustment/upper hole: 890-950 mm
Total adjustment: 840-950 mm.
Aligning of machine:
When the machine is placed and the wanted height is obtained, it must be
aligned to be level by the adjusting screws.
This is measured on the edges.
Adjustment of working height for automatic raise/lower:
From 800 mm to 1000 mm. (option)
Section/page:4.2
17/9/2013