GRAPHTEC Craft ROBO CC100 User Manual page 36

3.5.11-C Registration Mark Reading
(1) Use the [Blade Position] button to move the
blade to within the range of the registration
mark.
The range of the registration mark is displayed
as a green rectangle in the illustration at the
upper right corner of the Controller. The range
of the registration mark position may change
based on the orientation of the design.
Note: When the registration marks have been read, it becomes impossible to operate the [Registration
Marks] group box and [Design Orientation]. In addition, the [Calibration] button is disabled.
To enable operation again, turn the Standby switch of the Craft ROBO off, then on again.
This is displayed when Search Registration Marks is turned off.
It starts manual reading of the registration marks.
CHAPTER 3. CRAFT ROBO CONTROLLER
(2) After performing Step (1), click
on the [Registration Mark
Reading] button. It starts manual
reading of the registration marks.
3-19