Enable / Disable Area; Delete Area Or Measurements; Edit Limits - Automation Dr. Nix QNix 9500 Series Operation Manual

9500
Enabled area
The number of the enabled area will appear in the "Jobs / Area" bar in the measurement display.
When adding an area, the number will automatically increase.

4.7.3 Enable / Disable Area

You can enable or disable an area:
> Open the "Jobs" menu
> Select the desired job and press to confirm
> Select the desired area and press to confirm
> Enable or disable area
CAUTION
Enable / Disable Area
You can disable all areas, however when doing so the measurements will not be saved!
You can only enable one area at a time.
The job containing the enabled area will be selected.
NOTICE! If all areas are disabled, the "Job / Area" bar in the measurement display will be blank.

4.7.4 Delete Area or Measurements

> Open the "Jobs" menu
The current job will be selected
> Press to confirm
The current job will open with the current area selected
> Select the desired area and press to confirm
Erase all measurements in an area:
> Select "Erase measurements" and press
A confirmation message will appear
> Use the and buttons to confirm (☑ ) or cancel (☒ ), then press "OK" to confirm
NOTICE! A confirmation will not appear, the measurements in the selected area have been
erased.
> If necessary, enable the selected area and repeat the measurement
Erase entire area:
> Select "Delete area" and press to confirm
A confirmation message will appear
> Use the and buttons to confirm (☑ ) or cancel (☒ ), then press
NOTICE! A confirmation will not appear, if the selected area has been deleted. The numbering
will not change.
26 / 48 26
4 Operation and Controls
to confirm
to confirm
QNix 9500 EN_ES_FR_IT_NL_PL
4 Operation and Controls
4.8 Configure Limits
You can change the limit parameters in the "Limits" menu. You can configure a different limit set for
each area.
NOTICE

Edit limits

You can only change the limit set and the limits if there currently are no measurements. The func-
tion is disabled if any measurement has been carried out.
You can configure the limit set and the parameters if no area is active, presumed there are no
measurements.
> Open the "Limits" menu
> Select the desired limit set and press
> Press the button to open the limit set
> Adjust all limits and press to apply
> Close the limit set with or press the
Available options
Limits
No limits
Simple limits
Custom
ISO 19840
IMO PSPC
SSPC PA (Level 1-5)
QNix 9500 EN_ES_FR_IT_NL_PL
to enable
button to go directly to the measurement display
Unit
® ®
QNix 9500B QNix 9500P QNix
X X
X X
- X
- -
- -
- -
9500
®
9500P+
X
X
X
X
X
X
27 / 48 27