Star Network Modem
6.2.4 UDP Client instruction
(1) Set the protocol type to UDP Client, destination IP address (example: 192.168.4.2) and target port (8889),the target
IP should be consistent with the IP address of the computer.
(2)
Open the network test tool as shown in Figure 21, select UDP, select the IP (the destination IP address of the UDP
client), write the port (the target port of the UDP client) -> open, using the "Ebyte network configuration tool" "to monitor
the transmitted data.
Chengdu Ebyte Electronic Technology Co., Ltd.
20
Figure 20 Parameter setting instructions
Figure 21 Data transparent transmission
E70-DTU(433NW30-ETH)_User Manual