Ebyte E70-DTU User Manual page 22

Star Network Modem
complete, and then restart the device to search Check once to see if the parameter modification was successful.
(2) Open serial port assistant and network debugging assistants, set the parameter settings of the serial assistant and
module at same, open the network configuration software and set the network debugging assistant protocol type to UDP
Server, the network debugging assistant's server IP address is set to the module's IP address, set the target port of module to
8886, click Connect.
(3) Enter a string of data in the sending area of network debugging assistant A, click Send, you will see that network
assistant B has received the same data in the sending area of the serial port. Input a string of data in the sending area of network
debugging assistant A, network assistant B also received the data. It realizes bidirectional transparent transmission
Chengdu Ebyte Electronic Technology Co., Ltd.
19
Figure 18 Parameter setting instructions
Figure 19 Data transparent transmission
E70-DTU(433NW30-ETH)_User Manual