Ebyte E70-DTU User Manual page 30

Star Network Modem
mode, reset or restart the modem
3. When writing this instruction, the serial debugging assistant must be set not to send new lines; writing other AT
commands must be set to send new lines.
AT+EXIT Exit AT command mode
AT+EXIT
2
Example：AT+EXIT
Note: AT commands are invalid after exiting AT command mode
AT+HELP Help command
AT+HELP
3
Example：AT+HELP
AT+ RPCFG Reading the operating parameters
AT+ RPCFG
4
Example：AT+ RPCFG
AT+ WMCFG Setting /Querying working mode (reboot valid)
AT+ WMCFG =?
5
AT+ WMCFG =Value
Example：AT+ WMCFG =4
Note: 1. After setting a new mode, it needs to be reset or power off and restart
AT+DINFO Get facility information
AT+DINFO=ALLNODE
6
AT+DINFO=SELFS
AT+DINFO=SELFE
Example：AT+DINFO=SELFE
AT+ TFOCFG Setting/Querying output format configuration (reboot valid)
AT+ TFOCFG=？
7
AT+ TFCFG=Value
Chengdu Ebyte Electronic Technology Co., Ltd.
27
Parameter Description:
Null
Response:
Exit AT Mode
Parameter Description:
Null
Response:
All instructions and help information
Parameter Description:
Null
Response:
Return to the current operating parameters
Description:
Gets working mode
Response：
WMCFG：4
Description:
Value:0~4
0,Coordinator;
1, Normal node;
2, Dormant Node;
3, Sleep mode;
4, (factory default), dial switch control
Description:
Query the short and long address of all node, and return by UART.
It works only when the device works in the coordinator mode
Description:
Get short address and return by UART
Description:
Get long address and return by UART
Description:
Gets output format configuration
Response：
TFOCFG:0
Description:
Value：0~7
0：Output: valid data (transparent transmission)）
1: Output: Valid Data +Long Address
2：Output: Valid Data +Short Address
E70-DTU(433NW30-ETH)_User Manual