Advertisement
Electrical Installation
1. Remove the control box cover and
connect the UV LED Driver power cable
with the following:
UV LED DRIVER
Blue Wire: "L"
Red Wire: "N"
Notice:
UVC MINI KIT comes with a wide voltage 85-265VAC power supply.
2a. Connect the UV LED DRIVER cable connector to the strip directly, only
if the model is not equipped with either wired or remote controller.
Driver Cable
2b. If equipped with a wired control, connect the UV LED DRIVER cable to
one end of the wired control, and the other end to the UV LED Strip.
Driver Cable
2c. If equipped with a wireless controller, connect the UV LED DRIVER cable
to one end of the RF receiver, and the other end to the UV LED Strip.
Driver Cable
LED Strip Cable
Wired Control Cable
LED Strip Cable
RF Receiver
LED Strip Cable
Electrical Installation
3. Tuck the power cable into the line chase
on the back of the unit or place it under the
control box or other secure location.
UV LED DRIVER
a. Press once to
turn on/off
b. Long Press to
change strength
Or
Press once
to turn on/off
5. Apply the UV Warning Sticker to a proper location.
UV LED LIGHT
Prolonged exposure to direct LED UV light
may be harmful to eyes & skin.
This unit is equipped with an LED UV light disinfection system.
Disconnect power before servicing.
Indirect exposure (blue glow) is not harmful
4. T urn on the power supply and confirm
that the UVC MINI KIT is working.
CAUTION
Advertisement
