Advertisement
Mounting the UVC LED Strip
2. If needed, cut the strip into the length
that best ts into the space. (Cut-to-length
instruction is provided in this manual)
3.Peel off paper from the adhesive
backing on the LED strip. Do this a
few at a time and press it down
firmly onto the clean surfaces.
Place the LED strip so the light will shine onto the blower wheel
Cut the strip only following the instructions by manufacturer
DON'T AIM THE UV LIGHT INTO THE ROOM
1. Determine best location
Clean with cloth for any dust/dirt
Clean out with alcohol wipe
3.Pass the connector cable through
the drilled hole
Install the Light Shield Strip
UVC light shield strip is designed by the manufacturer and recommended
to be installed with the UV LED strip. It is adhesive with a special material,
to shield these lights which may be exposed INTO THE ROOM.
To install, simply peel off the paper
from the adhesive side and stick
firmly to the UV LED strip, with an
angle of 90°, upright.
Electric Installation Preparation
UVC LED Strip
Mini Split
Remote Control
Wired Control
(Optional)
(Optional)
RF Emitter
RF Receiver
Note:
Remote and wired control cannot be used
together
UV LED DRIVER
Red
Input: 85-265 V~
Blue
Output: 12 Vac, 2A
Advertisement
