Indoor Unit Installation; Select Installation Location - Pioneer WAS Series Installation Manual

Indoor Unit Installation

Installation Instructions – Indoor
Unit
PRIOR TO INSTALLATION
Before installing the indoor unit, refer to the
label on the product box to make sure that the
system set is a matching set for capacity, voltage,
and efficiency (indoor and outdoor).
Step 1: Select installation location
Before installing the indoor unit, you must
choose an appropriate location. The following
are standards that will help you choose
an appropriate location for the unit.
Proper installation locations meet the
following standards:
Good air circulation

Convenient drainage

Isolated enough to not cause disturbance

for other people
Firm and solid—the location will not vibrate

Strong enough to support the weight of the

unit
A location at least 1m (40 in) from all other

electrical devices (e.g., TV, radio, computer)
install unit in the following
DO NOT
locations:
Near any sources of heat, steam, or
combustible gas
Near flammable items such as curtains or
clothing
Near any obstacle that might block air
circulation
Near doorways
In locations subjected to direct sunlight
NOTE ABOUT WALL HOLE:
There are multiple options for piping routes:
While choosing a location, be aware that you
should leave ample room for a wall hole (see
wall hole drilling for piping connection step)
for the signal cable and refrigerant piping
that connect the indoor and outdoor units.
The wall hole position for all piping can be
located at either the right or left side of the
indoor unit (while facing unit). Pipes can also
be routed out from either side, or the bottom.
4
 
Page 11